Geo Pinpointer
Quick-Start Easy Use Card
1. Turn on control units power
2. Start laptop computer and start software
3. Make sure antenna and network cables are plugged in
4. Allow a few moments for programs to communicate with one another
5. When ready push Connect then Start to begin scanning
6. Keep antenna pointing down without turning, in the same direction(for best results)
7. In the Southern Hemisphere, south to north scans will provide best results.
Green- Background(common ground)
Blue - Negative Target(void, cave, tunnel)
Yellow/Orange - Medium Target
Red - Strong Target
Current Reading - Very useful for finding location of interest.
HIGH/LOW reading to distinguish between targets and target approximation
Change Defaults (as needed) example: For weaker targets set the high/low value to 10/-10 or 5/-5 for even weaker anomalies.
Scans Per Second - Number of readings per second may be increased for fast traveling.
Default - Resets values back to their preset levels.
- Pause often (Ground Balancing) every 1 or 2 minutes to reset to zero and clear past readings.
- For Depth Estimation, find the high reading on the target and walk away from target until you get 0 reading on the PinPointer. Be sure the area you are
- Walking away from is clear of any higher than ground balance readings before testing depth.
- Measure distance from the balance reading to target high mark, that distance will be the approximate depth of the target
- At time of pinpointing exact spot of interest, mark on ground for reference
